Mounting Kayak Spray Skirt on a kayak can be a hassle, as beginners and more experienced paddlers are fighting under the wrong conditions. Once the oarsman puts on the Kayak Spray Skirt and sits in the kayak with the skirt attached to the back, the hard work begins. They must pull and connect the rest of the skirt. Here are some methods, tips and precautions for connecting Kayak Spray Skirt to the kayak.

1. Install Kayak Spray Skirt
Grasp the jet skirt on both sides in front of the cockpit. Stretch Kayak Spray Skirt from both sides. When it stretches, try to manipulate the skirt so that it grabs the cockpit and combs as it moves up the cockpit. Also, when it stretches, slide your hands while holding the skirt up and grab the grip ring. You should reach a point where your hands are in front of Kayak Spray Skirt. Try to cover the tip of the Kayak Spray Skirt on the tip of the cockpit coaming.
2. Install Kayak Spray Skirt
If the Kayak Spray Skirt is too tight to be pulled forward from the side, it can be pulled out of the grip ring. The grip ring of Kayak Spray Skirt is the same as the tip. Fix the back of the Kayak Spray Skirt, hold the grip ring with both hands and pull it to the tip of the cockpit. Try to put it on top of the cockpit. At this time, you may need to adjust your back again and push the side over the edge of the cockpit to clean up.
3. Install Kayak Spray Skirt
If either of the first two methods does not work, you need to use a combination of the two. The problem is that the tighter the skirt is pulled, the more you want to get off the edge.
When you head forward, you need to keep the skirt on your back in some way. This can be done by holding the jet skirt on one hand and stretching from the grip ring or side on the other. Another option is to use your forearm to apply pressure to the middle of the Kayak Spray Skirt, because your hand presses the front part against the front of the enclosure.
The above are the 3 installation methods of Kayak Spray Skirt products, I hope it will be helpful to you.